COLD PIPE CUTTING AND ON SITE MACHINING

On-Site Machining
On-Site Machine Flange Facer Service provides a powerful, heavy-duty portable flange facer with rigid performance throughout the almost machine facing range. Our versatile selection of portable flange facer that be mounted internally, externally or both sides. Our service offer quickly re-faces flanges and repairs for piping and equipment as well as seal groove machining, counter boring and heat exchanger facing repair without disassembly and save downtime to maintenance.We can be done quickly and safety.

Our Onsite Machining Services cover the following
• Flange Facing
• Cutting and Weld Preparation
• Flatness Checks
• Surface Milling
• Drilling
• Bolting services which include: Torquing, Tensioning by, Joint Splitting, Joint alignment, Hot bolting & Nut splitting
• Boring and Stud Cutting
• Diamond wire cutting
• Line Boring
• Exchanger Work
• Exchanger Flange Machining
• Exchanger Division Plate Machining

Pipe Cold Cutting & Bevelling
Pipe Cold Cutting is the better practice than the outdated use of torches, reed cutters, and grinders because of its precision and higher level of safety when gas is still remain in line. Use the economic and very fast cold cutting and beveling, the pipe is ready to weld when we done. The portable pipe cutter avoids any heat affected zone (haz). Our Clam Shell Cutters are ideal for for heavy wall pipes with high wall-thickness in heavy duty applications.

Cutting and beveling services cover the following
1. Heavy Wall Piping
2. Cold Cutting
3. Beveling
4. Weld Joint Preparation
5. Reducer fittings
6. Elbows
7. Tees
8. Nozzle
9. Weld Excavation

Drilling
Holes of 8” in diameter to a depth of one metre can be achieved using our standard range of drilling machines. Trepanning holes of a larger diameter can be achieved using our standard range of cutting and facing machines.

Surface Milling
Milling rails of various lengths are available locally and are capable of operating in a 3-axis movement within 3m x 2m frame in a single set-up. Typical type of work completed using this equipment would be turbine half joint covers, pump and compressor mounting pads, etc. Milling of shaft slots, keyway cutting and slot cutting can also be carried out in-situ.